AXEON R1-Series - Manual (Page 7)

MKTF - 211
CONCENTRATE (WASTE WATER) CONNECTION
Locate the 1” or 3/4” connection (Depending on the unit)
the concentrate line to an open drain in a free and unrestricted manner (no backpressure).
that an air-break be used on the concentrate line to prevent siphoning of water from the pressure vessels
when the system is in standby.
CAUTION: ANY RESTRICTIONS OR BLOCKAGE IN THE DRAIN LINE CAN CAUSE
BACKPRESSURE, WHICH WILL INCREASE THE SYSTEM’S OPERATING PRESSURE. THIS CAN
RESULT IN DAMAGE TO THE SYSTEM’S MEMBRANES AND COMPONENTS.
ELECTRICAL
The motor used on the R1-Series
220/460 Volt, 50/60 Hertz, 1 Phase
cord.
Ensure that the electrical circuit supplying the system is compatible with the re
R1 model you are installing.
NOTE: IT’S RECOMMENDED
ACCORDANCE WITH LOCAL AND NATIONAL ELECTRICAL CODES (NEC).
WARNING: TO REDUCE THE RISK OF ELECTRICAL SHOCK, THE INCOMING
SUPPLY MUST INCLUDE A PROTECTIVE EARTH GROUND.
R1-Series systems are typically controlled with a liquid level switch in a storage tank. The liquid level
switch turns the system on when the water level in the tank drops, and off when the tank is full
level switches can be obtained by your local dealer or distributor. If a liquid level switch is to be used,
install it at this time.
PRE-FILTRATION
R1-Series systems are supplied with a
when a 10-15 psi differential exists between the two pre
about Pre-Filtration systems, if required.
NOTE: THE SYSTEM MUST BE OPERATED
PUMP
The pump used on the R1-Series systems is of the
Follow these guidelines to ensure proper operation of the pump:

The pump must NEVER
the pump.
7
211
CONCENTRATE (WASTE WATER) CONNECTION
1” or 3/4” connection (Depending on the unit) labeled concentrate and
to an open drain in a free and unrestricted manner (no backpressure).
break be used on the concentrate line to prevent siphoning of water from the pressure vessels
CAUTION: ANY RESTRICTIONS OR BLOCKAGE IN THE DRAIN LINE CAN CAUSE
BACKPRESSURE, WHICH WILL INCREASE THE SYSTEM’S OPERATING PRESSURE. THIS CAN
RESULT IN DAMAGE TO THE SYSTEM’S MEMBRANES AND COMPONENTS.
Series systems are pump and motor combination. The motor is available
hase/3 phase. Each R1-Series system is equipped with a 5 foot electrical
nsure that the electrical circuit supplying the system is compatible with the requirements of the specific
ED THAT A LICENSED ELECTRICIAN WIRE YOUR SYSTEM IN
ACCORDANCE WITH LOCAL AND NATIONAL ELECTRICAL CODES (NEC).
WARNING: TO REDUCE THE RISK OF ELECTRICAL SHOCK, THE INCOMING
SUPPLY MUST INCLUDE A PROTECTIVE EARTH GROUND.
systems are typically controlled with a liquid level switch in a storage tank. The liquid level
switch turns the system on when the water level in the tank drops, and off when the tank is full
level switches can be obtained by your local dealer or distributor. If a liquid level switch is to be used,
systems are supplied with a 5 micron sediment filter. Change the cartridge
ists between the two pre-filter gauges. Ask your local deale
Filtration systems, if required.
NOTE: THE SYSTEM MUST BE OPERATED USING FILTERED FEED WATER ONLY.
Series systems is of the multi-stage centrifugal stainless
Follow these guidelines to ensure proper operation of the pump:
be run dry. Operating the pump without sufficient feed water will damage
07/26/12
and attach to a drain. Run
to an open drain in a free and unrestricted manner (no backpressure). It is advised
break be used on the concentrate line to prevent siphoning of water from the pressure vessels
CAUTION: ANY RESTRICTIONS OR BLOCKAGE IN THE DRAIN LINE CAN CAUSE
BACKPRESSURE, WHICH WILL INCREASE THE SYSTEM’S OPERATING PRESSURE. THIS CAN
RESULT IN DAMAGE TO THE SYSTEM’S MEMBRANES AND COMPONENTS.
The motor is available in
system is equipped with a 5 foot electrical
uirements of the specific
THAT A LICENSED ELECTRICIAN WIRE YOUR SYSTEM IN
WARNING: TO REDUCE THE RISK OF ELECTRICAL SHOCK, THE INCOMING POWER
systems are typically controlled with a liquid level switch in a storage tank. The liquid level
switch turns the system on when the water level in the tank drops, and off when the tank is full. Liquid
level switches can be obtained by your local dealer or distributor. If a liquid level switch is to be used,
. Change the cartridge once a month or
. Ask your local dealer or distributor
WATER ONLY.
stainless steel type.
be run dry. Operating the pump without sufficient feed water will damage