Awntech SantaFe Series - Manual (Page 3)

NOTE: YOU WILL FIND THAT THE FITTINGS HAVE BEEN PRE-INSTALLED, AS WE
HAVE PRE-ASSEMBLED AND INSPECTED IT FOR YOU IN THE FACTORY.
Santa Fe Style Awning Frame must be installed on the wall as there is no
connecting part between SFB and TB
STEP 1: Separate all of the parts by part number so they will be easy to
assemble.
STEP 2: Top Bar (TB) must be installed first. C-Channel on the TB must be
close to the wall. Before installing the TB you must make sure that there is
enough space below the TB for the height of the awning. Example SANT22 style
will need 31” of the space for the height of the awning (please see the chart
below for the height measurements).
*** all the sizes are in inches
Model
Space
between
TB and
SFB in
inches
Height
incl
valance Projection Model
Space
between
TB and
SFB in
inches
Height
incl
valance Projection
SANT22 24 31 24 SANT22-NV 24 24 24
SANT32 36 44 24 SANT32-NV 36 36 24
SANT33 36 44 36 SANT33-NV 36 36 36
SANT34 36 44 48 SANT34-NV 36 36 48
SANT43 48 56 36 SANT43-NV 48 48 36
SANT44 48 56 48 SANT44-NV 48 48 48
ESANT2442 18 24 42 ESANT2442-NV 24 24 42
ESANT12 8 12 24 ESANT12-NV 12 12 24
ESANT1836 12 18 36 ESANT1836-NV 18 18 36
ESANT1230 8 12 30 ESANT1230-NV 12 12 30
ESANT1030 10 16 30 ESANT1030-NV 16 16 30
ESANT23 18 24 36 ESANT23-NV 24 24 36
ESANT24 18 24 48 ESANT24-NV 24 24 48
STEP 3: Santa Fe Bars (SFB) must be installed next. The space between Top of the (TB)
and the Bottom of the (FSB) must be according to the chart above.
STEP 4: Install the Front Bar (FB) to the projection side of the Santa Fe Bars (FSB).
The Velcro on the (FB) must face up.
STEP 5: Install the NC (left and right) with arrows facing upwards. The holes on the
(FB) and (FB) are pre drilled. Make sure that the Velcro on (NC) facing left and right
STEP 6: If the awning is larger then 4’ (52.5”) wide then you must install additional
(NC)s and (BP)s to complete the frame assembly and installation.
STEP 7: Once the frame is completely installed then secure all the joints where
connectors are attached by driving one self tapping screw from inside the frame.