Awntech Bostonian RB8 - Manual (Page 2)

PARTS LIST:
PARTS LIST:
PART
NO. QTY. DESCRIPTION
1 PLATE
R1 1 RIB 1
R2 1 RIB 2
R3 1 RIB 3
R4 1 RIB 4
R5 1 RIB 5
R6 1 RIB 6
R7 1 RIB 7
LPR 1 LEFT PROJECTION CURVE
RPR 1 RIGHT PROJECTION BAR
4 INSTALLATION “Z” BRACKETS
Hardware Pack 1/4x1-1/2 BOLTS, NUTS, Screws
1 Instruction Manual
TOOLS REQUIRED
(Not included): Electric Drill, ¼” nut Driver Bit, Full Socket Set, Full Set of Steel and
Masonry Bits, Tape Measure, Safety Glasses, 4’ Level, A Safe Ladder, #2 Pencil
YOU MAY ALSO NEED A HELPER DEPENDING ON THE SIZE, WEIGHT, LENGTH AND
HEIGHT OF THE AWNING
NOTE: YOU WILL FIND THAT THE FITTINGS HAVE BEEN PRE-INSTALLED, AS WE HAVE
PRE-ASSEMBLED AND INSPECTED IT FOR YOU IN THE FACTORY.
ASSEMBLING THE FRAME
STEP 2: Connect (R1) to (R7)
STEP 3: You may need a rubber mallet to fully seat the tubing onto the fittings.
STEP 4: Connect (LPR) to (RPR) to (R1) and (R7).
STEP 5: Install the PLATE to the top joint of (R1) and (R7) bars with (4) bolts. This requires a 7/16”
wrench.
STEP 6: Install the top of (R2), (R3), (R4), (R5) and (R6) to the PLATE and then Install the bottom
of the same bars to the (LPR) and (RPR) bars with two self tapping hex screws each.
STEP 7: Tighten all the bolts
STEP 8: From the inside of the awning, drill one self-tapping screw through the bars into each
connecting joint of the fittings.