Avlink YA-S8 - Manual (Page 6)

Installation
1. Connect the HDTV YPbPr RCA input connector and YA-S4/YA-S8 YPbPr RCA output connector
with YPbPr RCA cable.
2. Connect the HDTV Audio (R/L) or device Coaxial (Digital Audio) RCA input connector and
YA-S4/YA-S8 RCA output connector with Audio (R/L) or Coaxial (Digital Audio) RCA cable.
3. Connect the YA-Extender local unit RJ-45 output connector and YA-S4/YA-S8 RJ-45 input
connector with CAT.5 cable.
4. Connect the YA-S4/YA-S8 RJ-45 output connector and YA-Extender remote unit with CAT.5 cable.
5. Turn on the device and HDTV.
6. Adjusting EQ and GAIN to compensates the loss caused by the length of the cable.
Note:
ƒ EQ / GAIN adjustment: First, turn both knobs to minimum side (anticlockwise). Second, adjust
GAIN knob till screen turned on (with brightness changing). Then adjust EQ knob to change
screen sharpness. If the values of EQ or GAIN are too big or small during adjustment, it may
cause the screen disappeared or torqued.
ƒ For products with RJ45 interface and connected by CAT5 Cable, please use same method for EQ
/ GAIN adjustment. It’s required to adjust them step by step. If the values of EQ or GAIN are too
big or small, it may cause the screen disappeared or torqued. And the screen of each level
connected with this level through serial connection will disappear or become torqued.