Avlink YA-R4 - Manual (Page 9)

Installation
1. Connect the device YPbPr RCA output connector and YA-L RCA input connector with YPbPr RCA
cable.
2. Connect the device Audio (R/L) or Coaxial (Digital Audio) RCA output connector and YA-L Audio
(R/L) or Coaxial (Digital Audio) RCA input connector with Audio (R/L) or Coaxial (Digital Audio)
RCA cable.
3. According to the step 2, choosing Audio (R/L) or Coaxial (Digital Audio). Switchers are at the rear
side of YA-L & YA-R.
4. Connect the HDTV YPbPr RCA input connector and YA-R YPbPr RCA output connector with
YPbPr RCA cable.
5. Connect the HDTV Audio (R/L) or device Coaxial (Digital Audio) RCA input connector and YA-R
RCA output connector with Audio (R/L) or Coaxial (Digital Audio) RCA cable.
6. Connect the YA-L local unit RJ-45 output connector and YA-R remote unit RJ-45 input connector
with CAT.5 cable.
7. Turn on the device and HDTV.
8. Adjusting EQ and GAIN to compensates the loss caused by the length of the cable.
Note:
ƒ EQ / GAIN adjustment: First, turn both knobs to minimum side (anticlockwise). Second, adjust
GAIN knob till screen turned on (with brightness changing). Then adjust EQ knob to change
screen sharpness. If the values of EQ or GAIN are too big or small during adjustment, it may
cause the screen disappeared or torqued.
ƒ For products with RJ45 interface and connected by CAT5 Cable, please use same method for EQ
/ GAIN adjustment. It’s required to adjust them step by step. If the values of EQ or GAIN are too
big or small, it may cause the screen disappeared or torqued. And the screen of each level
connected with this level through serial connection will disappear or become torqued.