Artison Studio 39 - Manual (Page 15)

15
WIRING THE SOUNDBARS
3 CHANNEL METHOD (Left, Center and Right)
1. Operate the terminals by firmly pressing on them. An opening will be exposed in the
side of the terminal. Slip about 9 mm (3/8”) of bare speaker wire into this opening hole
and release the terminal. The spring loaded terminal will now securely hold the wire in
place.
2. Attach the three speaker wire pairs to the binding posts on the rear of the SoundBar.
The red terminal is the positive terminal and the black terminal is the negative terminal.
The outer sets of binding posts are Left and Right respectively and the center set of
binding posts is the Center Channel.
NOTE: The SoundBar is a 3 channel (Left, Center and Right) passive loudspeaker
device and requires 3 discrete audio signals from an external multi-channel amplifier.
The speaker wire gauge required is dependent upon wire length run, 16 gauge is
suggested as the minimum size.
12 gauge is the maximum that will fit into the
terminals.