AquaCraft Rio EP User Manual
Page 8
8
3. Slide the drive cable out the back of the stuffing tube. Wipe
off any old grease and water that may still be on the cable.
4. Apply a small amount of GrimRacer Speed Grease onto
the drive cable and slide it back into the stuffing tube.
5. Leave a 2mm gap [1/16"] between the front of the drive
dog and the end of the stuffing tube.
6. Tighten the set screws that hold the drive cable in place.
It is a good idea to tighten one screw lightly and then the
other. Go back and forth between the screws to keep even
tension on the drive cable.
See also other documents in the category AquaCraft Water equipment:
- Air Force (15 pages)
- Alligator Tours (12 pages)
- Atlantic (8 pages)
- Atlantic II (8 pages)
- Bristol Bay (8 pages)
- Hammer (8 pages)
- King's Ransom (12 pages)
- Mini Alligator Tours (8 pages)
- Mini Rio (12 pages)
- Mini Thunder (12 pages)
- Mini Wildcat (12 pages)
- Miss Vegas (12 pages)
- Miss Seattle (8 pages)
- Miss Vegas Deuce (16 pages)
- Minimono (12 pages)
- Motley Crew (8 pages)
- Nitro Hammer (8 pages)
- P-27 Gunslinger (8 pages)
- Paradise (12 pages)
- Pro Fisherman (8 pages)
- Reef Racer (8 pages)
- Reef Racer 2 (8 pages)
- Reef Racer 2 Charger (2 pages)
- Rescue 17 (8 pages)
- Revolt 30 (12 pages)
- Rio 51 (24 pages)
- Rio 51Z (16 pages)
- SuperVee 27 (11 pages)
- SuperVee 27R (16 pages)
- SuperVee 27 Nitro (12 pages)
- Top Speed 2 (20 pages)
- Top Speed 3 (24 pages)
- UL-1 Superior (12 pages)
- VS1 (20 pages)
- V24 One-Design (16 pages)
- Vela One Meter (16 pages)
- Wildcat (8 pages)
- 15 Marine Engine (4 pages)
- 18 Marine Engine (4 pages)
- 27 Rear Exhaust Airboat Engine (8 pages)
- 46 BB Marine Engine (6 pages)
- EP1 Electric Outboard Motor (4 pages)
- GrimRacer Precision Prop Balancer (4 pages)
- AQUB9540 Water Jacket Installation Procedure (4 pages)