AquaCraft Rio EP - Manual (Page 4)

4
ASSEMBLY
INSTALL THE TRANSMITTER BATTERIES
1. Slide the battery door off the bottom of the transmitter.
Install four fresh “AA” batteries into the transmitter
in the confi guration molded into the battery holder.
Reinstall the battery door onto the bottom of
the transmitter.
2. Turn the transmitter “ON” using the power switch on
the transmitter's right side. The battery level indicator
light (LED) should glow red. If the light is fl ashing, the
batteries are low and need to be replaced. Raise the
transmitter antenna.
INSTALL THE BATTERY
1. Rotate the cowl lock off the top of the cowl. Lift the front
of the cowl to unhook the cowl pins from the deck.
2. Place a charged 7.2V or 8.4V pack (see your charger
manual for charging information) into the Rio EP hull,
and secure it with the hook and loop as shown.