AquaCraft Miss Seattle - Manual (Page 8)

8
STRUT
The strut can be tweaked to change the ride of the boat but only
experienced modelers should attempt this. If you are going to
tweak the strut, remove the prop shaft and prop. Loosen the
strut bolt. Move or adjust the strut, taking care not to lose the
alignment of the driveshaft to the motor coupler. If needed,
you might have to re-bend this area to regain alignment.
Racing
Roostertail
Corner
Aquacraft Point
Turn
GrimRacer
Turn
150 ft
30 ft
Start/Finish
Drivers
MISS SEATTLE HYDROPLANE RACING RULES
Boats must remain stock. Only hardware adjustments are
allowed. Sharpening and scuffing are legal, but changing
a prop is not. You are also allowed to paint or add decals if
you choose.
A heat race is 6 laps and typically consists of up to 6 boats
per heat. You can run as many heats per event as you like,
but 3 to 5 is typical.
To start a race, set a timer to 30 seconds. Launch the boats
and make one full clockwise lap. At the end of the lap, you
need to be on the right side of the start line and going full
speed. Being over the start line at the end of the 30 seconds
puts you in last place. Be careful not to “jump the start.”
Cutting inside a buoy AT ANY TIME will incur a 50 point
penalty per buoy.
Points structure goes like this.
1 st place (per heat) 400 pts
2 nd place 300 pts
3 rd place 225 pts
4 th place 169 pts
5 th place 125 pts
6 th place 96 pts
In five rounds you have the potential to acquire up to 2,000 pts.
Good luck and good racing. Remember to place
your racing pictures and videos on the AquaCraft
Facebook page!
Ordering Replacement Parts
To order replacement parts for the AquaCraft Miss Seattle
Hydroplane, use the order numbers in the replacement parts
list. Replacement parts can be purchased from your local
hobby shop or by mail order. If you need assistance locating
a dealer to purchase parts, visit www.hobbico.com and click
on “Where to buy”. If you are missing parts, contact Hobbico
Product Support at:
Phone: 217.398.8970
Fax: 217.398.7721
E-mail: [email protected]
Parts List
AQUB6242 Cowl
AQUB6243 Hatch
AQUB6269
Wire Drive with Prop Shaft
AQUB6333 Decal Sheet
AQUB7731 31mm FRP Propeller, Blue
AQUB7852 Drive Dog with Prop Nut
AQUB7913 Motor Coupler
AQUB7914 Motor Mount
AQUB8735 Rudder Assembly Complete
AQUB8736 Rudder
AQUB8737 Rudder
O-Ring
AQUB8738 Rudder Control Arm
AQUB8742 Rudder Support Brackets
AQUB8771 Rudder linkage w/Control Arm
AQUB8813 Strut Assembly
AQUB9045 Water Pick Up
AQUB9277 Transom Drain Plug
AQUB9282 Turn Fin
AQUB9548 28mm CNC Water Jacket
AQUG7005 28-35-2200kV In-Runner Marine Motor
AQUM7003 30-Amp Water Cooled LiPo Controller
AQUM7050 Steering Servo
TACJ0300 TTX300 2.4GHz 3-Channel Pistol Grip Tx/Rx
TACL0325 TR325 Tactic 2.4GHz Receiver Only
AQUB1822Mnl
© 2014 AquaCraft Models, a Hobbico company.