AquaCraft Mini Alligator Tours - Manual (Page 3)

3
SETUP AND OPERATION
Plug the charger into a car power socket. The charger will start
beeping and the light will fl ash. Connect the battery pack to the
battery end of the charger. The charger will stop beeping and the
light will stop fl ashing. You will know charging is complete when
the charger starts to beep again and the light begins to fl ash.
Install eight “AA” batteries into the bottom of the transmitter.
Install the transmitter antenna into the top of the transmitter,
turning it clockwise to screw it in place. Then, turn the
transmitter on, making sure the power light is glowing.
Lift the rear edge of the seat compartment and rotate
the radio box cover up. Place it to the side.