Clarity 420 - Manual (Page 3)

Important Safety Instructions
owner’s manual. If you are not sure of the
voltage in your home, consult your dealer
or local power company.
10. Do not place anything on the power
cord. Install the telephone where no one
will step or trip on the cord.
11. Do not overload wall outlets or exten-
sion cords as this can increase the risk of
fire or electrical shock.
12. Never push any objects through the
slots in the telephone. They can touch
dangerous voltage points or short out parts
that could result in a risk of fire or electrical
shock. Never spill liquid of any kind on
the telephone.
13. To reduce the risk of electrical shock,
do not take this phone apart. Opening or
removing covers may expose you to dan-
gerous voltages or other risks. Incorrect reas-
sembly can cause electric shock when the
appliance is subsequently used.
14. Unplug this product from the wall out-
let and refer servicing to the manufacturer
under the following conditions:
A. When the power supply cord or plug is
frayed or damaged.
B. If liquid has been spilled into the product.
C. If the telephone has been exposed to
rain or water.
D. If the telephone does not operate nor-
mally by following the operating instructions.
Adjust only those controls that are covered
When using your telephone equipment, basic
safety precautions should always be followed
to reduce the risk of fire, electric shock and
injury to persons including the following:
1. Read and understand all instructions.
2. Follow all warnings and instructions
marked on the telephone.
3. Do not use this telephone near a bathtub,
wash basin, kitchen sink or laundry tub, in a
wet basement, near a swimming pool or any-
where else there is water.
4. Avoid using a telephone (other than a
cordless type) during a storm. There may
be a remote risk of electrical shock from
lightning.
5. Do not use the telephone to report a gas
leak in the vicinity of the leak.
6. Unplug this telephone from the wall outlets
before cleaning. Do not use liquid cleaners
or aerosol cleaners on the telephone. Use a
damp cloth for cleaning.
7. Place this telephone on a stable surface.
Serious damage and/or injury may result if
the telephone falls.
8. Do not cover the slots and openings on
this telephone. This telephone should never
be placed near or over a radiator or heat
register. This telephone should not be placed
in a built-in installation unless proper ventila-
tion is provided.
9. Operate this telephone using the electrical
voltage as stated on the base unit or in the
3
SAVE THESE INSTRUCTIONS
E
N
G
L
I
S
H