Antari WiFi800 User Manual

Page 5

1. One unit of Antari WiFi-800 Fog Machine

2. Power cord

3. User Manual

If any equipment is missing contact your ANTARI dealer immediately.

Before beginning your initial setup on ANTARI WiFi-800 Fog Machine, make sure that there

is no evident damage caused by transportation. In the event that the uni

t’s housing or

cable is damaged, do not plug it in and do not attempt to use it until after contacting your

ANTARI dealer for assistance.

 Setting Up

Step 1: Place the machine on a flat surface and in a suitable large area with at least 50 cm

open space around the machine.

Step 2: Fill the fluid tank with Antari approved fluid.

Step 3: Connect the machine to suitable rated power supply. To determine the power

requirement for the machine refer to the label on the back of the machine.

Step 4: Turn on the machine and allow it to heat up, while the machine is heating up the

LED status light on pushbutton wi

ll “Flash Red”. Heat up takes approximately 2 minutes.

Once the machine has reached operating temperature, the status LED will li

ght “Solid Red”.

Now the machine is ready for operation.

Step 5: To start making smoke, press the pushbutton locates on the handle; release

pushbutton to stop.

Step 6: To turn off the machine, put the power switch to the OFF position.

 App Download

Downloading the application

the WiFi-800 using your mobile devices with iOS / Android operating systems.