beautypg.com

Operation, Installation – Antari M-1 User Manual

Page 5

background image

5

The green light by the front of the handle will flash when the button is first pressed.
This indicates the battery has enough charge to power the M-1.

When the red light starts to flash, the battery needs to be charged. The machine will
still be able to fog for a short period of time after the red light begins flashing.

Operation

To generate smoke, press the button on the front of the M-1 Mobile Fogger’s handle.

There are two operation modes that can be selected for the M-1.

1. Operation mode 1. Allows the fog machine to fog as long as the button on the handle or

the remote control is pressed down. Once the button is released, the machine stops

fogging.

2. Operation mode 2. The M1 mobile fog machine produces fog by pressing the button on

the handle or remote controller once. To stop fogging, press the button again.

Use the small switch on the right side of the M-1. The switch is inside the case and is
adjusted through the small hole on the side of the case.

To select operation mode 1. Slide the switch towards the back of the M-1 (towards the
cap on the liquid tank).

To select operation mode 2. Slide the switch towards the front of the M-1 (towards
the nozzle).

When an optional remote is connected, please see the detailed instructions for its
operation below.

The machine will fog until the battery charge runs down or the M-1 runs out of fog liquid.
When the M-1 is connected to the optional power adaptor, carefully monitor the level of
the fog liquid to make sure the machine does not run out of liquid. Operating
continuously, the machine will run out of liquid in approximately 50 minutes.

A full battery charge will power the M-1 for a period of 10-12 minutes before needing to
be recharged. When using the battery, the charge will run down several times before the
fluid needs to be refilled.


Note: There is no warm-up time with the M-1 Mobile Fogger. Unlike most other fog machines,
you do not have to wait for the heater to warm-up before fogging.

Installation

The M-1 Mobile Fogger can be carried by hand or installed in a fixed location as desired.

Wherever the machine is placed, it is important that fog does not shoot directly at any one’s
face, at open flames or directly into any heat susceptible material.