AltiGen MAXCS 7.5 Salesforce Connector Configuration Guide - Manual (Page 15)

MaxCS Salesforce Configuration Guide Page 15 of 17
4. Set the MaxCS Connector log level to High (refer to the section Configuring MaxCS Connector
Settings starting on page 13. Browse several pages and then review the log file for information.
5. If the panel still will not open, contact AltiGen Technical Support.
Security Warning
While browsing in Internet Explorer, you may sometimes see “Do you want to view only the webpage
content that was delivered securely?” To disable this message so that it does not reappear, follow these
steps (these steps may vary from one version of the browser to another). The following steps apply to
Internet Explorer.
1. In the browser, click Tools > Internet Options > Security.
2. Click the Security tab.
3. Click on the Internet zone icon at the top of the tab page.
4. Click
Custom Level.
5. In the Miscellaneous section, change Display mixed content to Enable.
6. Repeat these steps for the Local intranet, Trusted sites, and Restricted sites zones.
Note: The security settings for your browser may block non-secured content, which could prevent
the pop-up from being displayed. It may be necessary to adjust your browser’s security
settings to display these pop-ups.
Privilege Warning
If a warning about privileges appears when using the MaxCS Connector, you can try this procedure to
avoid the recurring warnings. The following steps apply to Internet Explorer.
1. In your browser, click Tools > Internet Options > Security.
2. Click the Security tab.