Acura 2004 RSX - Owner's Manual - Manual (Page 63)

Turn Signal
Off
Parking and interior lights
Headlight on
High beams
Flash high beams
Rotating the
switch on the left lever turns on the
parking lights, taillights, instrument
panel lights, side-marker lights, and
rear license plate lights. Turning the
switch to the ‘‘
’’ position turns
on the headlights. If you leave the
lights on with the key removed from
the ignition switch, you will hear a
reminder beeper when you open the
driver’s door.
To turn on the high
beams, push the left lever forward
until it clicks. The blue high beam
indicator will come on (see page
).
Pull it back to return to low beams.
To flash the high beams, pull the
lever back lightly, then release it.
The high beams will stay on as long
as you hold the lever back.
With the headlight switch off, the
high beam headlights come on with
reduced brightness when you turn
the ignition switch to ON (II) and
release the parking brake. They
remain on until you turn the ignition
off, even if you set the parking brake.
The headlights revert to normal
operation when you turn them on
with the switch.
Push down on the
left lever to signal a left turn and up
to signal a right turn. To signal a lane
change, push lightly on the lever in
the proper direction and hold it. The
lever will return to center when you
release it or complete a turn.
1.
2.
3.
4.
5.
6.
52
Turn Signal and Headlights
Headlights On
High Beams
Daytime Running Lights
(Canadian Models)
Turn Signal
Turn Signal and Headlights
Instruments and Controls 60
Main Menu Table of Contents