Indicator lights – Acura 2004 TSX - Owner's Manual User Manual
Page 67
This indicator comes on for a few
seconds when you turn the ignition
switch ON (II). It will then go off if
you have inserted a properly-coded
ignition key. If it is not a properly-
coded key, the indicator will blink
and the engine will not start (see
page
).
This indicator also blinks several
times when you turn the ignition
switch from ON (II) to ACCESSORY
(I) or LOCK (0).
This light comes on when the
washer fluid level is low. Add washer
fluid when you see this light come on
(see page
).
This indicator lights when you turn
the ignition switch to ON (II) with
the headlight switch off and the
parking brake set. It should go off if
you turn on the headlights or release
the parking brake. If it comes on at
any other time, it means there is a
problem with the DRL. There may
also be a problem with the high
beam headlights.
This light comes on with the high
beam headlights. See page
for
information on the headlight
controls.
On Canadian models, this indicator
comes on with reduced brightness
when the Daytime Running Lights
(DRL) are on (see page
).
This indicator comes on when you
turn on the Cruise Control System
by pressing the Master Button. (see
page
.)
This lights when you set the cruise
control. See page
for information
on operating the cruise control.
Canadian models only
Canadian models only
Immobilizer System
Indicator
Washer Level Indicator
‘‘Daytime Running
Lights’’ Indicator
High Beam Indicator
Cruise Main Indicator
Cruise Control Indicator
Indicator Lights
Instruments and Controls
64
Main Menu
Table of Contents