Acura 2012 RDX - Advanced Technology Guide User Manual
Page 6
9
8
9
C u s t o m i z i n g S e t t i n g s
K E Y L E S S M E M O R Y S E T T I N G S
2. When you use the remote to unlock the vehicle, the ID number on
the back of the remote should match the memory button
illuminated on the driver door panel. Go to step 3.
• If the numbers still do not match after the remotes have been
linked, follow these instructions:
- Press the lock button on your remote, then press the
unlock button.
- Whichever memory button is illuminated on the driver
door panel should now match the number on the back of
the remote.
When linked, each remote (labeled 1 or 2 on the back) activates its own set of
programmable driving position memory and customized settings (MID).
1. Verify that the remote you are using is linked to the vehicle by pressing
the lock and unlock buttons at the same time. The LED light on the
remote blinks once to indicate that it is linked or twice if it is unlinked.
R e m o t e V e r i f i c a t i o n
3. Once the remotes are linked, you can begin to program your Keyless
Memory Settings.
D r i v i n g P o s i t i o n M e m o r y S y s t e m ( D P M S )
1. Turn the ignition switch to ON (II).
Shift into Park (P).
3. Press the SET button. You will
hear a beep.
2. Adjust your preferred seat and
outside mirror settings.
4. Press the memory button
corresponding to the remote
(1 or 2) you are using. You will
hear two beeps.
Note: Each group of settings is activated by the corresponding remote
transmitter (1 or 2). When activated, each item begins to adjust when you
open the driver’s door to enter the vehicle.
R E V E R S E T I L T D O O R M I R R O R
H o w I t W o r k s
When you shift into Reverse (R), the passenger’s outside door mirror tilts down slightly
to improve your view as you parallel park. Shifting out of Reverse returns the tilted
mirror to its original position.
• To tilt the passenger’s
door mirror, move the
mirror selector switch to
the right (R) position
when in Reverse.
• To turn the feature off,
move the switch to the
middle position or left (L)
position.
12 RDX ATG:ATG_NEW STYLE
7/6/2011
3:32 PM
Page 6