Acura 2013 TL - Technology Reference Guide (Base) - Manual (Page 7)

10 11
10 11
H O M E L I N K ®
Press and hold the button on the
remote and the HomeLink button at
the same time. Then, while
continuing to hold the HomeLink
button, press and release the button
on the remote every 2 seconds.
Does the LED blink at a faster rate within 20
seconds?
Press and hold
the HomeLink
button again. Training
complete
YES NO
HomeLink indicator
flashes for 2 seconds,
then remains on. HomeLink LED
remains on. YES NO
YES NO
Position the remote transmitter you
wish to link 1–3 inches from the
HomeLink button you want to program. 1
Press and hold the desired
HomeLink button and the button on
the remote transmitter.
Does the HomeLink indicator (LED) blink at a
faster rate after about 10 seconds?
2
a
The remote has a rolling code.
Press the “learn” button on the
remote-controlled device (e.g.,
garage door opener).
Press the programmed HomeLink
button again; the remote-controlled
device should operate.
Within 30 seconds, press and
hold the programmed HomeLink
button for 2 seconds.
a
Press and hold the programmed
HomeLink button for about a
second.
Does the device (garage door opener) work?
3
b
4
5
T r a i n i n g a B u t t o n
Program your vehicle to operate up to three remote-controlled devices around your
home, such as garage doors, lighting, or home security systems.
If you have any problems programming HomeLink, see the owner’s manual
included with the device you are trying to program, call HomeLink at
(800) 355-3515, or visit www.homelink.com.
BLUETOOTH
® HANDSFREELINK® (HFL)
Place and receive phone calls through your vehicle’s audio system. Visit
www.acura.com/handsfreelink to check if your phone is compatible.
HFL Talk button: Give HFL
commands and answer
incoming calls.
HFL Back button: Cancel a
command and end or decline
an incoming call.
P a i r i n g Y o u r P h o n e
Press and release the HFL Talk button before you give a command.
1. Enable discovery mode on
your compatible phone.
3. HFL gives you a four-digit
code (that also appears on
the MID) and begins to
search for your phone.
6. HFL asks you to name the
phone. For example, say
“Mary's phone.”
5. Enter the four-digit code on
your phone when prompted.
2. If no phone has been
paired before, the system
gives you instructions.
If you are pairing an
additional phone, say
“Phone setup,” then say
“Pair.”
4. Search for a HandsFreeLink
device from your phone, and
connect to HFL.
13 TL ATG_Base_ATG_NEW STYLE 8/14/2012 1:58 PM Page 7