Acura 2014 MDX - Advanced Technology Guide - Manual (Page 7)

11 10
Default Lock Setting
The doors are preset to lock
when your vehicle reaches
about 10 mph. Default Unlock Setting
All doors are set to unlock when
the driver’s door is opened.
How It Works
AUTO DOOR LOCKS
Program how and when the vehicle doors automatically lock and unlock.
1. Turn on the vehicle. Make sure
the shift lever is in Park (P).
2. Adjust the seat, outside mirrors,
and steering wheel to your
preferred positions.
4. Press the memory button
corresponding to the remote
(1 or 2) you are using within
5 seconds. You will hear two
beeps.
Notes:
• Once set, stored positions can be recalled by pressing one of the
memory buttons (1 or 2) on the door.
• Lumbar position cannot be stored.
DRIVING POSITION MEMORY SYSTEM (DPMS)
Store driver’s seat, outside mirror, and steering wheel positions into memory for each
corresponding keyless remote (1 or 2).
Programming the DPMS
3. Press SET. You will hear a beep.
1. Press SETTINGS. Use the
interface dial to make and
enter selections.
2. Select Vehicle Settings.
3. Select Auto Door Lock or
Auto Door Unlock.
4. Select from the options.
5. Press BACK to exit the menu.
Note: The driver’s and front passenger’s door can be opened by pulling the inner
front door handle, regardless of the setting. Changing the setting to “All Doors”
is useful for unlocking the rear doors and the power tailgate when a front door
handle is pulled.
* You can also change these settings using the
multi-information display (see page 8 ).
Changing Settings
Follow the steps below to change your door settings. Make sure you are using the
key you want to change settings for (Driver 1 or Driver 2) and the vehicle is on.*
14 MDX ATG_ATG Facing 3/29/2013 12:35 PM Page 10