Your vehicle is equipped with head restraints in all seating positions. Head
restraints are most effective for protection against whiplash and other rear-
impact crash injuries.
The center of the back of the occupant’s head
should rest against the center of the restraint.
The tops of the occupant’s ears should be level
with the center height of the restraint.

To raise the head restraint: Pull it upward.
To lower the head restraint: Push it down
while pressing the release button.
To remove the head restraint: Pull the
restraint up as far as it will go. Then push the
release button, and pull the restraint up and
out.
To reinstall a head restraint: Insert the legs
back in place, then adjust the head restraint to
an appropriate height while pressing the release
button. Pull up on the restraint to make sure it
is locked in position.

For a head restraint system to work properly:

• Do not hang any items on the head restraints or from the restraint legs.
• Do not place any object between an occupant and the seat-back.
• Install each restraint in its proper location.

Sitting improperly or out of position can result in serious injury or death in a
crash.
Always sit upright, well back in the seat, with your feet on the floor.

WARNING

rear center seat

Front or rear outer seat

Improperly positioning head restraints reduces their effectiveness and
increases the likelihood of serious injury in a crash.
Make sure head restraints are in place and positioned properly before driving.

WARNING

Failure to reinstall, or correctly reinstall, the head restraints can result in severe
injury during a crash.
Always replace the head restraints before driving.

WARNING

Floor Mats

Position the front and rear seat floor mats
properly, and anchor them. If they are not
properly positioned, the floor mats can interfere
with the front seat functions.
Do not put additional floor mats on top
of the anchored mats.

Driving Position Memory System

You can store two driver’s seat, steering wheel, and door mirror positions into
memory when the vehicle is on. When you unlock and open the driver’s door, the
driver’s seat slides rearward to allow for easy entry. The seat slides forward to the
stored position and the other items adjust when the vehicle is turned on. The items
adjust automatically to one of the two preset positions.

1. Adjust the seat, steering wheel, and mirrors to your

preferred positions.

2. Press SeT.
3. Press and hold memory button 1 or 2. You will hear

two beeps when the memory is set.

Press one of the memory buttons to recall previously
stored positions.
Lumbar positions cannot be stored.

Unlock

Lock

Memory

button 1

Memory

button 2

SET button