Panasonic EY0214B - Manual (Page 2)

MPORTANT SAFETY
NSTRUCnONS
>:>AVE THESE
TRUCTIONS r..
manual contains important safety and
operating Instructions for battery
charger EYQ214.
2) Before using battery charger, read ail
instructions and cautionary markings
on (1) battery charger. (2) battery
pack.
3)
CAUTION
-To reduce the nsk
of injury, charge only Battery Pack as
shown below.
EY9103, EY9101, EY9001. EY9006,
EY9180, EY9080, EY9182, EY9086,
EY9065, EY9106, EY9107, EY9136,
EY9117, EY9230, EY9200. EY9108.
EY9210
Other types of batteries may burst
causing personal injury and damage.
4) Do not expose charger to rain or
snow.
5} To reduce risk of damaging the electric
plug and cord, puM by plug rather than
cord when disconnecting charger.
6) Make sure cord is located so that it will
not be stepped on, tripped over, or
otherwise subjected to damage or
stress.
7) An extension cord should not be
used unless absolutely necessary.
Use of Improper extension cord could
result in a risk of fire and electric
shock. If extension cord must be
used, make sure;
a. that pins on plug of exteneon cord
are the same number, size and
shape as those of plug on charger.
b. that extension cord Is properly
wired and in good electrical
condition.
c. that wire size is large enough for
ampere rating of charger as specified
below.
RECOMMENDED MINIMUM AWG SIZE OT
EXTENSION CORDS FOR
BATTERY CHARGERS
AC Input Rating. Ampefas AWG Size of Cord
Equal to or But less Length of Cord, Feet
graatar than than 25 50 too 150
0 2 18 16 18 16
8) Do not operate charger with
damaged cord or plug—replace them
imfTtediately.
9) Do not operate charger If it has
received a sharp blow, been
dropped, or otherwise damaged in
any way; take it to a qualified
serviceman.
10) Do not disassemble charger; take it
to a qualified serviceman when
service or r^air is required. Incorrect
reassembly may result In a risk of
electric ^ock or fire.
11) To reduce the risk of electric shock,
unplug charger from outlet before
attempting
any maintenance or
cfeartirig.
12) The charger and battery pack are
specifically designed to work
together. Do not attempt to charge
any other cordless tool or battery
pack with this charger.
13) Do not attempt to charge the battery
pack with any other charger.
14) Do not attempt to disassemble the
battery pack housing.
15) Do not store the tool and battery
pack in locations where the
temperature may reach or exceed
122°F (50**C) (such as a metal tool
shed, or a car in the summer), which
can lead to deterioration of the
storage battery.
16) Do not charge battery padc when the
temperature is BELOW 32‘F (0”C) or
ABOVE 104*F (40"C). This is very
irr^Kxrtant.
-1 -