Panasonic MK-G20NR-W - Manual (Page 5)

Parts Identification
@Switdi
(b)LocWng knob
©Motor housing
©Opening
©Food pusher
©Hopper plate
©Head
©Feed screw
©Cutting blade
©'©Attachments
©Cutting plate (fine)
©Cutting plate (medium)
©Cutting plate (coarse)
©Sausage attachment A
©Sausage attachment B
©Kubbe attachment
(to be used with @)
©Cap
How to Use
Before Use
Make sure that the voltage and frequency indicated on
the bottom plate are the same as your local supply.
Wash all the parts (except those that do not toucii foods
(D
t ® r © snd @) in warm soapy water.
Before plugging in, ensure the switch is off.
To mince meat
Follow the lliustration of P.2, the sanie number as in
thetx>x.
(ftssembUng)
I 1 ~j Place the head tightly onto opening of the motor
housing. Holding the head with one hand, plar^
the kx^ng knc* into foe hole on the side of the
motor housing and tighten it clockwise.
I
2
j
Place the feed screw into foe head, long end first,
by turning foe feed screw slightly until it is set into
the motor housing.
[ 3I Place the cutting blade onto the feed screw shaft
with the blade facing foe toitnt as illustreted.
•ffftisnotfitiedFffDperty. meat wit not be ground.
I 4^ Place desired the cutting plate next to the cutting
ttede, ft^ng protmsncxts in foe slots.
\ 5 I Screw cap into place until tigM,
’ Do not over ti^iten.
Race the hopper plate on the head and fix into
position.
Locale the unit m a fmn place.
* Tire air passage at bottom and the side of the
motor housing should be kept free and not blocked.
(imiKtng meaQ
Cut all foods into pi^res so foat foey fit easily
into the iK^^jer openfog.
Plug in, then switch on.
] 6 I Feed foods tnio the hopper plate.
•Use the food pusher.
After use, switch off and unpiog.
—
3
—