Panasonic NE-3280 - Manual (Page 13)

HowÌQ^Pfierate
G. CYCLE COUNTER
♦ 7b
Read Total Cumulative Times That The Oven Has Been Used:
PAD INSTRUCTION DIGITAL DISPLAY WINDOW
1 Open the door and leave it open.
The oven lamp will turn on and “0” will appear.
n
u
2 Close the door.
Carry out Step 3 within 60 seconds of closing the door, or the display
will go blank.
n
u
3
0^0
BEEP PnOG
While pressing Beep Control Button, press Program Entry Button.
The display shows the total cumulative number of times the oven has
been used.
g 99 99
Self Diagnostics ^^UiJi^Code Explanation
This oven monitors its operation and displays a Failure Code in the display window when a problem occurs.
What to do when a failure code appears:
CODE CAUSE WHAT TO DO
F01 Overcooked food.
Temperature of exhaust air too high.
Unplug the appliance to stop beeping.
Wait for appliance to cool down to reset operation.
If food ignites, do not open the door.
If normal operation does not resume, call the service
agent with information of failure code.
F03
F04
Incoming line voltage too high.
This oven is designed to operate
with 208 or 220-240 Volts AC.
Incoming voltage too low.
Check line voltage and that voltage adjustment is
matched.
(Refer to page 5 for power source voltage
adjustment.)
Line Volt. Connetor Color
208 V White
220-240 V Black
If the line voltage is other than 208 or 220-240 V,
consult electrician to check outlet.
Unplug the appliance and wait more than 1 minute
and reconnect.
If normal operation does not resume, call the service
agent with information of failure code.
F05
F33-34
F44
F81-F84
F86-F89
Defective Memory 1C.
Defective thermistor circuit.
Defective control panel.
Defective relay circuit.
Note: Above codes shown in the display do not indicate all the possible failures on the unit.
-
13
-