E. beep tone, To select loudness level and length “3 beeps, Instruction – Panasonic NE-3280 User Manual
Page 12: To select length of tone long beeps for 60 seconds, F, program list, While pressing stop/cleartime pad, press start pad, In nn i tu uu, 8 n uu, F. program list, Howtq^^rate
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

HowtQ^^rate
E. BEEP TONE
The loudness of beep tone and its duration at the end of heating cycle can be set.
There are four levels of the loudness and two levels of duration.
The loudest level and 3 beeps are preset at the factory.
♦
To select loudness level and length
“3
beeps*':
PAD
INSTRUCTION
DIGITAL DISPLAY WINDOW
1
o
PROG
Press Program Entry Button.
«' “PROG” sign will start to blink in the display window. (The door may be
open or closed at this stage.)
■m-
o
BEEP
Press Beep Control Button.
The tone will sound at its loudest level (level “3”) and the word "bEEP”
will appear. “PROG” will start to blink and 1st Stage Heating Indicator
“1 ” (the length of beep tone “3 beeps”) will be indicated.
Note: Repeating to press Beep Control Button will lower the loudness
level all the way to silent. (3bEEP — loudest, 2bEEP — middle,
IbEEP — quietest, and ObEEP — silent)
^ b E E P
O
PROG
Press Program Entry Button again.
^
“PROG” will stop blinking. That means that you have completed
program.
Three seconds later, the display window will go blank when the door is
closed.
^ 3 b E E P
♦
To select length of tone long beeps for 60 seconds’
PAD
INSTRUCTION
DIGfTAL DISPUY WINDOW
3
a
Follow steps 1 to 3 of above.
^ b E E P
4
0
BEEP
Within three seconds after pressing Program Entry Button, press
Beep Control Button.
^ “PROG” will start to blink and 2nd Stage Heating Indicator “2” (the
length of beep tone “long beeps for 60 seconds”) will be indicated.
i
5
0
PROG
Press Program Entry Button again.
“PROG" will stop blinking. This means that you have completed programming.
Three seconds later, the display window will go blank when the door is
closed.
' a b E E P
i
F, PROGRAM LIST
PAD
INSTRUCTION
DIGITAL DiSPUY WINDOW
Open the door and leave it open.
•• The oven lamp will turn on and “0” will appear.
n
u
STW
While pressing Stop/ClearTime pad, press Start pad.
All currently programmed information (the program set into each
Memory pad (A/B sides), Beep Tone, and Program Lock information)
will continuously appear.
“ i n n n
I t u u u
>8 n u u
3
b E E P
I
t-
-
12
-