Kofax Export Connector for Fax 1.1.0 - Manual (Page 5)

Kofax Export Connector for Fax Administrator's Guide 5
Administrator's Guide
This guide contains information about the installation and use of Kofax Export Connector for
Fax. The export connector enables you to route documents through Kofax Capture to a fax
server as faxes.
During the export connector setup, you configure your fax server properties (such as the
server name) and specify fax settings (such as the fax number and subject).
Tip For Kofax Front Office Server users, lookup lists for fax numbers and email addresses
can be created as index fields in Kofax Capture for use in the Kofax Front Office Server Thin
Client and MFPs. See the Kofax Front Office Server Administrators Guide for instructions.
Overview
The export connector provides you with the following features:
▪ Ability to route a document to a fax server for exporting
▪ Ability to specify your fax server properties (such as the server host name or IP address)
▪ Ability to specify the fax information (such as the sender’s and recipient’s fax number)
based on Kofax Capture data
▪ Support for the following fax servers:
▪ Kofax Communication Server
▪ RightFax Fax Server
▪ Biscom FAXCOM Fax Server
Note If you are using RightFax or Biscom FAXCOM, be sure the client software for the fax
server is installed on each client workstation where the export connector is installed.
Supported Image Format for Kofax Export Connector for Fax
Only .TIF image files are supported for export with the export connector, based on the
following image format options:
▪ Resolution (dpi)
▪ 204x98 (Standard fax; preferred)
▪ 204x196 (Fine fax; preferred)
▪ 200x100
▪ 200x200
▪ 100x100