Kimber Model 8400 User Manual

Page 15

E2. Unloading the Model 8400 Montana Rifle (No Floorplate)

1. Repeat Steps 1 through 4 in section E1.
2. Keeping the muzzle pointed in a safe direction, push the bolt handle

slowly forward, just until the next cartridge is released from the magazine.

Caution:

The cartridge may possibly slide forward into the chamber if the

bolt is pushed to far forward. Normally, the cartridge will slide back with
the bolt if the bolt is pulled rearward. If the cartridge remains in the
chamber, then you must slide the bolt all the way forward and push the
bolt handle downward to close the bolt. THE GUN IS NOW READY TO
FIRE. Then repeat #1-4 of section E1 to remove the cartridge.

3. Pull the bolt handle slowly to the rear position. With your free hand over

the ejection port, the cartridge should come free of the bolt.

4. Repeat #2 & 3 until the magazine well is completely empty, and the

chamber is empty.

Warning: Visually inspect the magazine and chamber to confirm that there
are no cartridges in the rifle.

Trap Door Release Button

Loaded Cartridge