CFM Corporation DVT38IN - Manual (Page 24)

24
Chateau™
20011956
Chimney Components
Horizontal Starter Kit Contains 24”-40” telescopic pipe* for minimum vertical SK8DVSK
rise from collar pipe, 90° elbow, horizontal
through-wall starter pipe, zero clearance sleeve,
metal adhesive tape, stove cement tube, sidewall
termination and firestop.
SK8 Chimney Sections Pipe used to build 8” (SK8) flue systems. SK81 (1’ Long)
SK818 (1Z\x’ Long)
SK83 (3’ Long)
SK84 (4’ Long)
SK8 Chimney Elbows Elbow used to create an offset in an 8” SK830-2 30° Elbow*
chimney system. (2 per pkg.)
SK845 45° Elbow*
SK890 90° Elbow*
Firestop Required at each floor level of chimney SKFS2A —
installation. (Plus attic on multi-story installation.) (8” straight flue)
SK8DVFS
(Horizontal Firestop)
Zero Clearance Sleeve Used when horizontal pipe goes through an interior SK8ZCS
vertical wall.
Attic Insulation Shield Used to prevent insulation from coming in contact with AIS-SK
the chimney system.
Chimney Support Used to support chimney for each of: 30’ vertical SKCS8
height and 6’ of angled chimney run.
Round Top Termination Top used to terminate chimney at roof.
(Flashing not included.) RLTSK8
Round Top Termination - Top used to terminate chimney at chase.
Extended (Flashing not included.) RLTSK8L
Flashing Metal finishing required around termination 8-6-12 with 8” flue:
to prevent rain leakage. 0-6/12 pitch
8-12-12 with 8” flue:
6/12-12/12 pitch
Housing Extensions Extends Square Termination on steep 202036
pitched roofs.
Chase Top Housing Low profile pyramid-style chimney cap used to PTLSK8
terminate chimney through a chase. Includes
adapter. (Flashing not included.)
Chase Top Housing Square chimney cap used to terminate chimney SLTSK8
through a chase. Terra Cotta Masonry. Includes
adapter. (Flashing not included.)
Horizontal Termination Cap used to terminate venting through a sidewall. SK8DVRVT
Model Number Description Component
NOTE: The 24”-40” telescopic pipe is only intended for use with the SK8DVSK.
* Factory unitized elbow