CLIFFORD bULLET II - Manual (Page 10)

What each button/channel does
Your Bullet II remote controls come pre-programmed so that certain channels
command certain functions. If you wish, you can actually assign any channel to any
function (see pages 15-16). The following chart indicates what each remote control
channel number does, and how to transmit each channel number.
Factory settings of the 12 remote control channels
Transmitting
channel
number:
Causes the system to:
Press the
LevelShift
button?
How
many
times?
Press
button
number
1 arm or disarm and lock or unlock the doors no — 1
2 optionally pop the trunk (if the system is
disarmed)
no — 2
3 silently arm or disarm no — 3
4 activate optional accessory function #1 no — 4
5 remotely enter or exit valet mode (see page 11) yes once 1
6 optionally turn on the headlights yes once 2
7 activate optional accessory function #2 yes once 3
8 activate optional accessory function #3 yes once 4
9 activate optional accessory function #4 yes twice 1
10 activate optional accessory function #5 yes twice 2
11 activate optional accessory function #6 yes twice 3
12 activate optional accessory function #7 yes twice 4
TO ARM
THE SYSTEM . . . . . . . Press button 1 (channel 1) once. You will hear two chirps and
the parking lights will flash twice. The dashboard LED will
flash repeatedly and the car doors will automatically lock.
TO DISARM
THE SYSTEM . . . . . . . Press button 1 (channel 1) again. One chirp and one parking
light flash confirms disarming. In addition, the doors will
automatically unlock and the interior lights will turn on and
stay on for 30 seconds or until you start the engine, whichever
occurs first.
TO SILENTLY
ARM OR DISARM . . . Press button 3 (channel 3). The system will arm or disarm
with all the indications noted above except the chirp
acknowledgments.
8