Flylink HD Motion Detection G-sensor - Manual (Page 4)

menu interface;
2) Press Down key ⑹ then choose the detailed parameters.
3) At last ,press the Confirm key ⑺ and confirm the operation.
4) After finishing all the setting,press the Menu key ⑷ again,then it will close the
setting interface.
 Parameter
1. Video resolution:(1920*1080)(1440*1080)(1280*720),default
setting(848*480)(640*480)(320*240)
2. Menu language:English(default
setting)/French/Spanish/Germany/Italian/Simple Chinese/traditional
Chinese/Russian/Japanese/Korean
3. Format :deleting all information in the TF card
4. Frame rate: 1920*1080 24fps,other video resolution are with 30fps
5. Light frequency:50Hz(default setting) /60Hz
6. Date/Time:in standby mode,press the Menu key ⑷ twice,it enters the
setting interface,then press the Down key ⑹ and set the date&time, then
press the Conform key ⑺ to save .
7. Recording time:OFF/1minute/3mintues(default setting)/5minutes ; when
choosing OFF,the DVR will stop recording when the TF card is full,and it
will not record cycle.
8. Time stamp:OFF/ON(default setting). When choosing OFF,the video will
not be with time stamp.
9. Default setting: Cancel/Confirm. When choosing Confirm,the DVR will
restore to factory settings.
10. Motion detection:OFF(default setting)/ON
11. Audio recording:OFF/ON(default setting)
12. Version:show the software version number and the publishing time of
software
 Download Files
Connecting the DVR to the computer by the USB cable,there are two options on
the displaying screen(memory card/camera), please remember to insert the
memory card,at the time,choose the “memory card”,it appears the U disk,then we
can download the files.
AV OUTPUT
Connect the DVR to the TV by the AV out cable,and the screen of the DVR will be
off,and all the video will be displayed on the TV.
 Attention:
1.please insert the TF card to the DVR before recording.