Cuisinart WOK-730 - Manual (Page 4)

ASSEMBL
Y/
DISASSEMBL
Y INSTRUCTIONS
1.
Place base on a flat clean surface where you intend to cook. Locate the
wok
release switch
on one
corner of the base (Fig.
A).
Place your index finger and middle finger inside the open channel and pull out the release bar (Fig. B). The button in the center of the bar will pop up.
The
wok release switch
should
be in the open position before placing the wok onto the base.
2.
T
o
secure the wok to the base,
hold the wok directly over the base lining up the probe socket area with the appropriate cutout in the base (Fig. C). Place the wok onto the base.
Locate the
wok release switch
on the base. Push in the button on the release bar (Fig. D).
The bar will slide back into its original position locking the wok to the base (Fig. E).
T
o
remove the wok from the
base, make sure that the power cord has been unplugged from the wall outlet and the
temperature control
probe
has been remove
from the wok. Locate the
wok release switch
on the base. Place your index finger
and middle finger inside the open channel and pull out the release bar
.
The but-
ton in the center of the bar will pop up. Lift the wok up to remove.
3.
Y
our wok includes a
steamer rack
and a
tempura rack
that can be used
depending upon the types of foods you are preparing. Steamer Rack The
steamer rack
is used when
preparing steamed dishes. If you intend to use the wok for steam- ing, the
steamer rack
should be
placed on the bottom of the wok with the triangle-shaped feet fac- ing down.
The
steamer rack
will
rest a couple of inches above the bottom surface of the wok.
4
A.
B.
D.
E.
C.
04CU13116 WOK-730 IB 6/22/04 10:41 AM Page 4