EKLIPES EKLIPE Motorcycle / Automotive 12 Volt Battery & Alternator Tester - Manual

__________________________________________________________________________________
HOW TO USE YOUR NEW EKLIPES BATTERY TESTER
Insert your new EKLIPES Battery Tester into your 12 Volt Cigarette Lighter or 12 Volt Power Socket and the Tester will
Automatically Light up. Do Not Start your Vehicle.
Once you have inserted the EKLIPES Battery Tester into your 12 Volt Power Socket or Cigarette Lighter you may have to turn
on your key to the on position to give power to the socket but do not start your vehicle.
If the red Light on the tester comes on this means you may have a bad battery and you should possibly check the following
items, Fluid levels in your battery, possibly Loose alternator belt;
If the red and yellow LED lights are lit up on the EKLIPES Battery Tester this means your battery is in good condition. If the
yellow LED lights up, This indicates that your battery is in normal condition and not to worry.
HOW TO TEST YOUR REGULATOR AND ALTERNATOR
Start your Vehicle ’s engine for 15 Minutes, Then plug in your new EKLIPES Battery Tester to your 12 Volt cigarette lighter or
power socket. If the red and green LED lights up this means your alternator is working very well and the output from your
alternator to your battery is very good.
If the green LED lights up this means your battery is being charged normally.
If the green and yellow LED light up, This means your battery is low and may need a charge soon or you need to have your
battery checked by a service tech as soon as possible.
Brookshire Innovations, LLC
Home of EKLIPES Product Lines
Office: 1(916)-786-7601 Fax: 1(916)-786-7607
www.EKLIPES.com