Cub Cadet 200 Series - Manual (Page 7)

200 Series Single Stage Snow Throwers
3
3.4. Remove the bearing housing and bearing from
the auger shaft. See Figure 3.4.
NOTE: The left side (Drive Side) has a washer
located between the auger housing and bearing.
3.5. Remove the three screws holding the right side
bearing housing on with a 3/8” wrench.
3.6. Remove the right side auger bolt with a 7/16”
wrench. See Figure 3.6.
Figure 3.4
Figure 3.6
3.7. Remove the auger by sliding it to the left side of
the housing and tilting the right side out. See
Figure 3.7.
3.8. After the short end of the auger shaft has been
removed, there will be enough clearance to with-
draw the long threaded end of the shaft from the
housing
4. RUBBER AUGER SPIRAL REPLACEMENT
4.1. Lean the snowblower back so that it rests on its
handlebars. See Figure 4.1.
NOTE: The rubber spirals and flats can be
replaced without removing the auger from the
housing
4.2. Remove the 20 self tapping screws attaching the
rubber spirals and flats to the auger assembly
using a 3/8” wrench.
4.3. Attach new auger spirals to the auger assembly.
Figure 3.7
Figure 4.1