Cub Cadet 200 Series - Manual (Page 5)

200 Series Single Stage Snow Throwers
1
1. INTRODUCTION
1.1. For the 2005-2 manufacturing year several
changes have been made to the single stage
snow throwers.These changes are detailed in
this section of the manual.
1.2. Disclaimer: This service manual was intended
for use by trained technicians.The information
contained in the manual is current and accurate
at the time of writing, but is subject to change
without notice.
1.3. Description: The 200 series single stage snow
thrower is designed with the typical residential
user in mind.The snow blower weighs approxi-
mately 70lbs and is compact enough to store in
smaller areas. This machine is equipped with a
2-cycle Tecumseh Snow King engine.Similar
models are also powered with 4-cycle Tecumseh
engines. See Figure 1.3.
NOTE: Before servicing, or repairing the snow
thrower. Stop engine and wait until the engine
has cooled.Disconnect the spark plug and
ground it to the engine to prevent unintended
starting.
Figure 1.3
MODEL #
31A-240-800
2. DRIVE BELT REMOVAL
2.1. Remove the 5 perimeter screws using a 3/8”
wrench or socket. See Figure 2.1.
2.2. The front screw used in holding the belt cover on
is shorter than the other four and is a fine
thread.It is necessary that this screw be used to
allow for clearance to the auger assembly. See
Figure 2.2.
Figure 2.1
Perimeter Screws
Shorter Perimeter
Screw
Figure 2.2
Clearance
200 Series Single Stage Snow Throwers