Chicago Electric 67845 - Manual (Page 8)

Page 8 For technical questions, please call 1-800-444-3353. Item 67845
Operating instructions
Read the entiRe impORtant SaFetY inFORmatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tool Set up
tO pRevent SeRiOuS inJuRY FROm aCCiDental OpeRatiOn:
make sure that the power Switch/trigger is in the off-position and unplug the tool
from its electrical outlet before performing any procedure in this section.
Charging
1. Place the Battery Pack on a dry fireproof surface in
a room where the temperature is from 50–104° F.
note: If recharging a newly spent Battery Pack,
allow it to cool completely before charging.
2. Examine the Battery Pack. It must be
undamaged, and a NiCd type Battery Pack.
Do not charge a cracked, open, or
leaking Battery pack, or charge a
non-recommended type of Battery pack.
3. The Battery Pack’s terminals are designed to fit
this Charger specifically. If the Battery Pack does
to not fit the Charger properly, do not try to insert it.
Do not force a Battery pack into the Charger.
4.
Figure B
Charger (36) Adapter (37)
LED Light Flanges
Plug the Adapter into a grounded,
120V~, 60Hz receptacle.
5. Connect the Power Supply to the Charger.
6.
Charger (36) Battery Pack (35)
Flange
Figure C
Slide the Charger onto the Battery Pack.
note: The Battery Pack’s capacity will increase
somewhat during the first few charging cycles.
A fully discharged Battery Pack will take about 2-1/2 to
3 hours to fully charge. Recharging the Battery Pack
for more than 5 hours can damage the battery cells.
7. While charging, the Battery Pack, Charger, and
Power Supply may become warm to the touch.
This is normal, and does not indicate a problem.
8. The red LED will light continuously while the Battery
Pack is charging. It will change to green once the
Battery Pack is fully charged. Unplug the Charger and
disconnect it from the Battery Pack when finished.
9. Allow the Battery Pack to cool
completely before using it.
10. Press the Battery Buttons to release
Battery Pack from the Charger.
Workpiece and Work area Set up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
3. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
Sa
Fet
Y
Ope
R
ati
O
n
m
aintenan
C
e
Setup