Cub Cadet 7264 - Manual (Page 32)

32
HEAD LIGHT BULB REPLACEMENT
The tractor is equipped with four headlight bulbs. If
one of the bulbs should burn out, replace the bulb
as follows:
• Fully raise the hood so that the hood prop
cylinders hold the hood in the raised position.
• Pull both locking tabs of the wire harness plug
away from the bulb/socket assembly and
unplug the wire harness from the bulb
assembly. See Figure 37.
Figure 37
• Turn the bulb/socket assembly approximately a
quarter turn counterclockwise to align its tabs
with the notches of the reflector, then remove
from the reflector.
• Replace with a new bulb/socket assembly (Cub
Cadet No. 725-3161A).
• Align the tabs of the new bulb/socket assembly
with the notches of the reflector and insert the
bulb.
• Turn the bulb/socket assembly clockwise to
lock in place. Plug the wire harness into the
socket, making sure the plug locking tabs lock
onto the socket assembly.
TAIL LIGHT BULB REPLACEMENT
Each tail light assembly has two light bulbs — a
reverse indicator bulb (Cub Cadet no. 725-3263)
and a tail light (Cub Cadet no. 725-3262). Access
the back side of the tail lights from under the rear
fender.
NOTE: Use caution when removing the tail light
sockets from the reflector housings. The bulbs can
be pulled from the sockets and dropped into the
reflector housing, requiring removal of the reflector
housing to retrieve the bulb.
Replace a tail light bulb as follows:
• Turn the light socket counterclockwise to align
the socket tabs with the notches in the tail light
reflector.
• Once aligned, carefully pull the light socket out
of the tail light reflector.
• Pull the light bulb from the socket and replace
with a like part.
• Align the tabs of the socket with the notches in
the reflector and carefully insert the socket.
Turn the socket fully clockwise to lock in place.
HAZARD BULB REPLACEMENT
Flashing hazard lights are installed on each side of
the ROPS. Replace the bulbs as follows:
• Grasp the outer half of the light housing and
both the front and rear lenses. Accessing the
screws from the notches at the top and bottom
of the outer housing, remove the two screws
fastening the outer and inner housings
together. See Figure 38.
Figure 38
• Remove the outer housing and lenses.
• Push in on the bulb and turn counterclockwise
to remove the bulb from the light socket.
• Align the new bulb with the socket slot, push
the bulb into the socket, and turn clockwise to
lock it in the socket.
• While making certain the lenses engage the
front and rear grooves of the inner housing,
install the lenses and outer housing. Secure
with the two screws.
BULB/SOCKET
ASSEMBLY.
WIRE
HARNESS
PLUG
LOCKING TAB
REFLECTOR
OUTER
HOUSING
INNER
HOUSING
BULB
LENSES
SOCKET
NOTCH
NOTCH
SCREW