Preparations, Filter installation, Remote controller preparations – Coway AP-1005AH User Manual

Page 8

Safety

Information

Operating

Instructions

Troubleshooting

ips

ustomer

ervice

PREPARATIONS

Filter installation

- Please remove packing vinyl before installation.
- Make sure to use only in indoor and separate plug from outlet when

the product is not used.

- Check front side of filter.

▶Filter order : pre- filter→medium filter→HEPA filter→Ag allergy shield filter→Deodorant filter

Open front cover and take
filter case out.

�

Place filter case on the floor, remove packing for each filter and put
them in the case in reverse according to filter steps.

�

Pull the lower part of front
cover, and lift it to open.
Pull side handle to take out
filter case from the product.

Check filters front side during filter installation.
In case of Ag allergy shield filter, place the filter in its own case with black side
front and put it in the filter case.

�

Deodorant filter

Ag allergy shield filter

Medium filter

HEPA filter

To install pre- filter, place pre- filter at
the 6 hooks of filter case correctly with
FRONT mark front.

�

Place the lower part of filter case first
and push the upper part of the case in.
Install front cover into the
product and close it.

�

●

�

Filter case hook

Remote controller preparations

- If remote controller does not work, check if life-time of battery is over due.
- Use the same size of two AAA batteries to change them.
- Take the batteries out if the remote controller is not used for a long time.
- The life-time of batteries may be differing from the frequency of remote controller.

During using of remote controller

- use remote controller facing the receiving part of the product.
- The remote controller can not work if there is any obstacle between the controller

and the product.

- Do not impact remote controller.
- Do not keep the controller in a wet place or direct rays of the sun, and near heat of fire.

How to use remote controller

①

②

Open remote controller pushing
down the rear part and pushing
down the battery cover, and
place AAA size battery setting
positive and negative pole.
Close the cover pushing up the
cover.