Bio Bidet Harmony Luxury Class Bidet Seat BB-400 - Manual (Page 4)

7 Installation Manual and Operating Instructions 6 Installation Manual and Operating Instructions
PREP
ARA
TION
CAUTION
Never operate this product if it is not working
properly, if it has been dropped or damaged,
or dropped into water. Return the product to
a service center for examination and repair.
Prohibited
Do not obstruct or put
anything into the dry air
outlet. Do not apply
excessive force to the
shower nozzle.
Prohibited
Do not strain or push the connected hose and tube connecter;
it may cause water leakage. Never drop or insert any object
into any opening or hose. Use proper plumbing supplies if any
modification is to be made.
Prohibited
Drain the water from unit and unplug the power if it is
not going to be used for an extended period of time.
Refer to page 19
Observe at all times
Do not stand or sit on
the seat cover lid.
It is not designed to
support a user s
body weight.
Prohibited
Allow the seat
and lid to close
automatically
do not force the
lid closed.
Prohibited
Use this product only as described
in the operating instructions. Never
use while sleeping or drowsy.
Do not use while bathing.
Observe at all times
Be careful so that
this product does not
become stained with
excrement and urine.
Observe at all times
- SAVE THESE INSTRUCTIONS -
THIS PRODUCT MUST BE PLUGGED into a regular voltage Grounded GFCI outlet (North
America 120V ac, 60Hz / Europe 220-240V~ , 50/60Hz). The rated power consumption is 660W /
600-700W. In locations where only a standard two-prong outlet is available, it is the responsibility
of the user to install a grounded three-prong outlet. Using a higher voltage is dangerous and may
result in a fire or other accident. This product is not responsible for damage resulting from the use of
it on other than specified voltage, or operating it without proper grounding.
WIRING REQUIREMENT
This product has a three-prong grounding plug, which must be plugged into an outlet that is properly installed and
grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an
escape wire for the electric current. If repair or replacement of the cord or plug is necessary, do not connect the
grounding wire to either flat blade terminal. The wire with insulation having an outer surface that is green with or
without yellow stripes is the grounding wire. Check with a qualified electrician or serviceman if the grounding
instructions are not completely understood, or if in doubt as to whether the product is properly grounded.
This product is for use on a nominal 120V circuit, and has a grounding plug that looks like the plug illustrated in
sketch A in Figure 1. A temporary adapter, which looks like the adapter illustrated in sketches B and C, may be
used to connect this plug to a 2-pole receptacle as shown in sketch B if a properly grounded outlet is not available.
The temporary adapter should be used only until a properly grounded outlet (sketch A) can be installed by a qualified
electrician. The green colored rigid ear, lug, or the like extending from the adapter must be connected to a permanent
ground such as a properly grounded outlet box cover. Whenever the adapter is used, it must be held in place by the screw.
This appliance has to be earthed.
GROUND INSTRUCTIONS
GROUNDING PIN
ADAPTER ADAPTER
METAL SCREW
TAB for
Grounding Screw
GROUNDED
OUTLET
- Figure 1-
The use of an extension cord is not recommended or advised. If it is necessary to use an extension cord, use
only a three-prong extension cord (one to one), and a three slot built-in GFCI receptacle that will accept the
plug on this product. The marked rating of the extension cord should be equal to or greater than the electrical
rating of the unit (10amp). Consult a qualified electrician or service person if you are not sure whether the unit is
properly grounded.
IMPROPER GROUNDING CAN RESULT IN A RISK OF ELECTRIC SHOCK.
Electric wiring has to be done in accordance with all local codes,
or in the absence of local codes, with the National Electrical Codes.
DANGER
This Product must be on a separate circuit.
No other appliance should share the circuit with this product.
Sharing a circuit could cause the branch circuit fuse to blow
or the circuit breaker to trip. Continuous usage under these
conditions could result in fire or property damage.
WARNING
GROUNDED
OUTLET BOX
2 CAUTIONS BEFORE INSTALLATION
(1)
(2)