Barcus Berry 1460-N12 User Manual
Page 8
4) Use variable speed drill with 15/32”(11.9mm) to drill through enlarged
end pin hole.
5) Remove all wood debris from saddle slot, then feed transducer cable
through hole in saddle slot. Carefully place transducer into saddle slot with-
out bending or twisting. Be sure transducer rests flat in the bridge slot and
that the transducer cable is not binding in its hole.
6)Prepare the Barcus Berry Fas-Jac™ endpin jack for installation by plac-
ing the lock washer onto the electrical contact end of the jack. Then place
the hex nut over the lock washer and screw it on about 5 to 8 turns.
7) Prepare to solder cable elements to Fas-Jac. Place cardboard square or
similar material on top of (above) guitar, to protect guitar while soldering
connections. Place Fas-Jac on cardboard, then bring transducer cable up
through the soundhole. Separate about 1”(26mm) of the braided wire shield
at the end of the cable, exposing the center plastic shielded wire.