AYRE AX-5 - Manual (Page 20)

To enter the advanced setup mode, make sure that
the amplifier is in the low-current consumption
state (green LED illuminated on the right-hand
button). Then press and hold the left-hand button
for three seconds. This enters the unit into the basic
setup mode. The display will briefly show
“ SET UP ” and then display “ XXX 1 ” where
“XXX” is the name assigned to input 1.
Use the right-hand knob to select which input
(
1 - 6 ) you wish to configure with advanced options.
Then briefly press the right-hand button to enter
the advanced menu level. The left-hand knob will
select which setting you wish to configure for that
input:
•
CN - Custom Name
•
GOS - Gain Offset
•
PP - Processor Pass-Through
•
AL - AyreLink
•
RST - Reset
After you have selected the desired choice, press the
right-hand button to enter the selection.
18
XXX 1
SET UP
CN
GOS
PP
AL
RST