AvaLAN Wireless AW-5800mT - Manual (Page 6)

aW5800mT User’s Manual
PaGe 6 Technical support :: (650) 384.0000 www.avalanwireless.com
Technical specifications
Limited warranty
This product is warranted to the original purchaser for normal use for a period of 360 days from the date of purchase. If a defect
covered under this warranty occurs, AvaLAN will repair or replace the defective part, at its option, at no cost. This warranty does not
cover defects resulting from misuse or modification of the product.
Appendix A — Agency certifications
FCC Certification
The AW5800mT OEM RF Module complies with Part 15 of the FCC rules and regulations. Compliance with labeling requirements, FCC notices and
antenna regulations is required.
Labeling Requirements
In order to inherit AvaLAN’s FCC Certification, compliance requires the following be stated on the device:
Figure 1. Required FCC label for OEM products containing the AvaLAN AW900mT OEM RF module
The Original Equipment Manufacturer (OEM) must ensure that FCC labeling requirements are met. This includes a clearly visible label on the outside
of the final product enclosure that displays the contents shown in the Figure 1.
rF transmission rate
ethernet throughput
Output power
receive sensitivity
radio link budget
range
radio channels/bandwidth
automatic frequency select
Connector types
status leDs
error correction technique
regulator type
Power consumption
Voltage
Temperature range
Transmit current draw
size
1.563 Mb/s
935 Kb/s
+21 dBm (20 Watts EIRP used with 23 dBi antennae AW23-5800)
-98 dBm at 10e-4 BER (-121 dBm with 23 dBi antennae AW23-5800)
128 dB with 5 dBi antenna AW5-5800
164 dB with 23 dBi antennae AW23-5800
2 miles LOS with 5 dBi antenna AW5-5800
30 miles LOS with 23 dBi antennae AW23-5800
58 non-overlapping with 2.0833 MHz spacing and 1.75 MHz occupied bandwidth
Yes, radio channel automatically selected and adaptively optimized
RF RPSMA Female / Ethernet RJ45 10BaseT / Power Jack P5-2.1 mm ID
Power, Ethernet Link, RF RX, RF TX, 6/Channel, and 6/Link Quality
Sub-block error detection and retransmission
Switching regulator
Transmit: 1.8 W
receive: 1.0 W
AC 12-24 VAC at screw terminal
DC 6-48 VDC at P5 power jack (center positive)
DC 6-48 VDC at screw terminal (reverse polarity correction)
Power over Ethernet 9-48 VDC over Ethernet — pairs 4/5 positive and 7/8 ground
-40
o C to 70 o C
350 mA at 6 VDC
150 mA at 12 VDC
40 mA at 48 VDC
90 x 65 x 33 mm
CHaraCTerIsTIC sPeCIFICaTIOn / DesCrIPTIOn