Analogue Solutions Telemark /-K - Manual (Page 16)

A
analogue Solution – Telemark – 2014 16 | P a g e
Telemark-k Pitch Bend and Mod Wheel

PITCH BEND WHEEL
Pitch Bend range can be set via the LCD display. Default value is usually set to +/-2 semitones. The Pitch
Bend MIDI data is sent to the MIDI OUT socket and will also control the on board MIDI to CV converter to
affect the pitch of both VCOs equally.

MOD WHEEL
The mod wheel will send MIDI controller one data to the MIDI Out socket. MIDI2 (CV2) can be set to be
modulated by any controller, therefore can be set to one to be controlled by the mod wheel. This means
that the mod wheel can be used to change, say, filter cutoff.
 