acidlab Bassline2 User Manual
Page 20
20
Inputs
Audio In
Audio in (6.3 mm, mono) is an audio input, that disconnects the audio signal path
before the filter.
The external signal is fed instead of the saw tooth or the square wave signal into the
filter.
FM In
FM in is an input (3.5 mm of mono) to modulates the cutoff frequency of the filter.
The FM input is suitable, to modulate the filter with audio signals.
Outputs
CV-, Gate- und Accent-Outputs:
Over the sockets CV Out and Gate Out (3.5 mm, mono) compatible synthesizers can
be played. CV Out is a 1V/Oktave control voltage for the pitch, and Gate Out is a
+12V impulse with the note length information.
The Accent Out is a gate out signal, with a +12V impulse. The Accent Out is primarily
used to control the Acidlab Bombass, but can be used to gate compatible
synthesizers, too.
Audio Outputs:
Output is the main output (6,3 mm of mono), to connect a mixer. Headphones is a
headphone output (3.5 mm stereo).
Both Outputs are controlled with volume.
The produced bass frequencies are a large load for following amplifiers and
loudspeakers.
Without protection they can take damage!