Windy Nation Windtura 750 Wind Turbine Generator - Manual (Page 7)

7
Windtura 750 Assembly Instructions
The Windtura 750 comes partially assembled. The 750 Watt generator has been pre-attached
to the generator/yaw mount at the factory. Additionally, the yaw bushing and slip ring have
been pre-attached at the factory.
Attach the blades to the hub:
Figure 1: Blade to hub assembly diagram
Notes: Be careful not to hit, bend or damage the blades while assembling the blade rotor as
this could make the blades unbalanced! Once you are finished attaching the blades to the
hub, lay the blade/hub assembly on a flat surface as shown in Step 3 in Figure 1.
Step 1: Locate the bag which is labeled “Blade to Hub Fastener Set”. This bag should contain the
following fasteners: 12 stainless steel bolts, 12 stainless steel k-lock nuts, and 12 stainless steel
flat washers. Lay the hub on a flat surface and attach the blades using the fasteners. Refer to
Step 1 in Figure 1 above to see the proper fastener orientation for attaching the blades to hub.