Harbor Freight Tools Model 94446 - Manual (Page 5)

SKU 94446 For technical questions, please call 1-800-444-3353. Page 5
loading the tool
Warning! Disconnect the Stapler from the air compressor whenever loading or servicing. After
disconnecting the Stapler from the air compressor, there could still be enough air pressure to
fire the Stapler. After the air compressor hose is disconnected, always fire the Stapler into a
piece of scrap to make sure all of the air is expended.
1. Grip the Sleeve (78) and pull out the Magazine Cover (72).
Caution: the Magazine Cover (72) may snap closed with force, sometimes without
warning.
2.
Cleats
FigUre 1
Install fasteners:
Cleats – Place the Cleats into the larger slot in the magazine so that the top of the cleat
rests on the rail in the center of the magazine. See
Figure 1, above.
Staples – Place the staples over the center rail of the magazine.
note: Only use the fastener types and sizes listed on the Specifications Chart on page 2.
3.
While holding the Sleeve (78) securely, slide the Magazine Cover (72) closed.