Panasonic MC-V7375 - Manual (Page 9)

CABPETBAJRE FL£)ORSEyE
To use cleaner on bare floors, the
carpet/bare floor selector on top of the noz­
zle should be positioned all the way back
and down toward the bottom of the nozzle
until it locks into place. When the selector is
in this position the agitator does not turn. This
is also the correct position to place the selector
in to use the attachments. Any time the attachments
are used the agitator shouid not be turning.
To use cieaner on carpeted areas, the carpet/bare floor
selector should be all the wav forward and up to the carpet
position. This will allow the agitator to turn. When carpets are being cieaned the
selector should remain in this position.
Take care when selecting either position to make sure the selector is pushed fully and quickly
as possible to the desired position. Failure to do so can cause the belt to rub on the selector
shaft and may result in the belt becoming hot and creating a burning rubber smell.
To prevent injury when returning the selector to the carpet position, use caution as the selector
can move quickly upward due to tension caused by the belt.
Ban Floor/
Carpet Selector
To clean bare floor
or use attachments
To clean carpet
HOSE RING AND HOSE RING MOUNT
Hose
Ring Knob
The hose ring is a feature designed to prevent tipping
while performing certain tasks that involve the use of
the attachments. To use this anti-tip
feature, place the hose ring in the hose
ring mount as shown in the illustra­
tion. Rotate this ring on the hose so
that the hose ring knob will align
with the slot in the hose ring
mount and slide the ring down
firmly until it stops. For recom­
mendations on when to use the
hose ring and the exact location
of the hose ring mount see the
ATTACHMENTS section.
of the vacuum
-
9
-