Panasonic ES765 - Manual (Page 7)

A full charge will supply enough
power for about 14 shaves (three
minutes per shave for a normal
beard).
You can always store your shaver in
the charging adaptor to maintain full
power capacity. This shaver cannot
be overcharged.
Before traveling, charge it fully for 1
hour if you will not be taking the
charging adaptor with you.
In case your shaver is discharged,
you may quick charge it for one
shave in about five minutes.
For a better shave
Put a thin layer of shaving foam on
your face which works as lubricator.
Do not put a thick layer of shaving
foam as it becomes messy. If the
shaving head is clogged with foam,
simply rinse it under running water.
Hold
the shaver at a right angle
(90“) to your skin (see fig. 3).
Depress the switch lock button and
slide the On/Off switch upward to
turn the shaver on. Start out shaving
by applying gentle pressure to your
face. Stretch your skin with your free
hand and move the shaver back and
forth in the direction of your beard.
You
may gently increase the
amount of pressure as your skin
becomes accustomed to this
shaver. Applying excessive pres-
sure does not provide a closer
shave and may irritate skin.
System outer foil and lift
strips
(see fig. 4)
System outer foil has a slit blade (a)
between two foils (b), and a lift strips
(c) on each outside of the foils. They
move up and down independently to
follow the contours of your face .
The lift strips lift lying hairs and help
introduce the hairs into the holes of
foils to cut. The slit blade catches
and cuts longer and lying hairs easi-
ly-
Using the trimmer
(see fig. 5)
Slide the trimmer handle up to
the "" position until it clicks in.
Place the trimmer at a right angle to
your skin and move it downward to
trim sideburns.
Cleaning your shaver
(see fig. 6)
After every shave, press the foil
frame release button to pop open
the foil frame. Turn the shaver on
and rinse the inner blades under
running water or in a basin. After
rinsing, switch the shaver off and
leave it to dry without closing the foil
frame and the protective cap. After
the shaving head dries, close the foil
frame
and replace the protective
cap on the shaver.
Replacing shaving head
components
With daily use, the outer foil may
need to be replaced every year and
the inner blades every 2 years.
Replacing the system outer foil
(see fig. 7)
Squeeze
the system outer foil
release buttons and lift the system
outer foil upward to remove it. To
insert the new system outer foil,
press down until it snaps into place.
Replacing the Inner blades (see
fig. 8)
Press the foil frame release button