Panasonic KX TC910DB - Manual (Page 26)

Before Requesting Help
Problem Remedy
An alarm tone sounds when
you press 1
TALK! or
lINTERCOMl.
o You are too far from the base unit.
Move closer and try again,
o Place the handset on the base unit
and try again,
o Plug in the AC adaptor.
An alarm tone sounds
continuously while using the
handset.
*» Move closer to the base unit quickly,
or the call will be terminated within 60
seconds.
o Plug in the AC adaptor.
The unit does not work. o Check the setting (p. 8-10).
o Charge the battery fully,
o Clean the charge contacts and charge
again.
Static, sound cuts in/out, fades.
Interference from other
electrical units.
o Set the handset and the base unit
away from electrical appliances,
o Move closer to the base unit,
o Raise the base unit antenna,
o Press to change the channel.
The unit stops working during
operation. o Place the handset on the base unit
and unplug the AC adaptor to reset.
Plug in, then try again,
o Re-insert the handset battery within 5
minutes and try again.
The handset does not ring. o The ringer volume is set to OFF.
Press 1 LOUD/RINGER 1 when the
TALK/BATT LOW indicator light is off.
The base unit does not ring. o The RINGER selector is set to OFF.
Set to HIGH or LOW.
You cannot store a phone
number in memory.
o You cannot store a number while the
unit is in the talk, speakerphone or
intercom mode.
o Do not pause for over 30 seconds
while storing.
26