Panasonic EH366 - Manual (Page 7)

Operation
(See B]-© on page 5.)
© Insert the plug into a wall outlet.
@ Press the POWER button.
(3) Continue pressing the POWER button
until the indicator for the desired mode
is lit.
• Interval mode operates at normal air flow
rate only.
• During automatic mode or interval mode,
the operating light for the selected mode
will light together with the air flow rate
light.
Lights light in order
© Automatic
© Interval
@ Low
0 Middle
® High
(D Off (no lights lit)
Timer operation
(Timer cannot be set during
automatic operation.)
(See gKDon pages.)
© Press the Timer button.
@ Continue pressing the TIMER button
until the indicator for the desired time
period is lit.
• During timer operation, the light for the
remaining operating time will be lit.
• For example, if the timer was originally
set to 4 hours and 2 hours have passed,
the 2-hour lamp will be lit to indicate that
2 hours remain.
Lights light in order
© 1 hour
© 2 hours
@ 4 hours
0 8 hours
® Continuous (no lights lit)
About the motion sensor
(See 5 on pages.)
© The detection region is approximately as
shown in Fig. LLl page 5.
® Heat emitted by humans body is detected
and the movement of people is determined.
• Movement of domestic animals may also
be detected.
CAUTION:
© Sensor sensitivity varies with distance
and angle in relation to the sensor.
• Aim the sensor toward the position
where people’s movements is ex­
pected, using the detection area dia­
grams at left as a guide.
© Do not place in areas the product in
direct sunlight or in close proximity to
heat sources.
• Sensor may not operate properly in
such cases.
MAINTENANCE
WARNING:
Unplug AC cord from the wall outlet before
cleaning.
Ensure that the dust and pollen collected on
the filter or intake grill are not spread around.
Main unit
Damp a cloth with soapy water and wipe the
main unit.
Never use benzene, paint thinner, etc.
intake griii
Use the brush or other vacuum cleaner
attachment to periodically remove the dust
from the grill. You can also remove the
intake grill from the main unit and wash.
Pre-fiiter
Use a vacuum cleaner to remove dust or
wash with water and let dry completely be­
fore reinstalling.
Do not rub while washing and do not blow
hot air on it or let it come in contact with
flames.
HEPA filter
Replace with a new filter. This filter cannot
be cleaned, washed and re-used washed
with water.