Panasonic Ultra Pro MC-V300 - Manual (Page 17)

CLEANING EKrERK)R^Dn
^^■ït---------- -
1. Unplug cord from wall outlet. DO NOT drip water on cleaner.
2. Clean exterior using a clean, soft cloth that has been dipped in a solution of mild liquid
detergent and water and wrung dry. Wipe dry after cleaning.
3. To reduce static electricity and dust build-up, wipe outer surface of cleaner and attachments.
4. Wash attachments in warm soapy water, rinse and air dry. DO NOT clean In dishwasher or
clothes washer.
DO NOT USE ATTACHMENTS IF THEY ARE WET.
A
CAUTION
Attachments used in dirty areas, such as under a refrigerator, shouid not be used
on other surfaces untii they are washed. They couid ieave marks.
REMC^NG CLOGS
The hose located on the back of the vacuum cleaner carries the dirt from the nozzle
up to the dust bag. If the hose should become clogged;
1. Unplug the power cord from the outlet
before checking the airflow passages. Pull
open the suction inlet cover and check for
clogging in this area.
2. Disconnect the hose from the back of the
vacuum and check hose for clogging. Plug in
the vacuum cleaner and turn it on. While run­
ning the vacuum cleaner with the hose discon­
nected, stretch the hose in and out to remove
the clog. Re-insert the hose into the opening
on the lower body from which it was removed.
Press firmly to assure connection,
3. If the clog still exists, turn the vacuum
cleaner OFF and unplug the power cord. Turn
the vacuum cleaner over, exposing the under­
side. Remove the lower plate, check the noz­
zle area and remove any visible clogs.
Reinstall the tower plate. See the REMOVING/
INSTALLING THE LOWER PLATE section for
detailed instructions.
Clean-Out
Port Cover
-
17
-