Panasonic COMBI WAVE NE-C1153 - Manual (Page 17)

How to release the Program Lock
ACTION INFORMATION DISPLAY
1 Open Door. The oven lamp will come on.
MICRO Tllbtf PROGRAM
COW PRfeHEAr
2 Press
Program Lock Key.
Lock^
Keep key pressed for 2 seconds until “P L" is
displayed.
KEEP DOOR OPEN.
After 2 seconds, “P" appears in display window.
After 3 seconds, display reverts to “0”.
MICRO riM^ PROGRAM
\ I /
_OL
J
_
/ U
/ I ^ /1 \
COfi/ PREHEAT
MICRO TIME PROGRAM
COW PREHEAT S
MICRO TIME PROGRAM
COMV PREHEAT
Two Touch Operating Mode
The oven reverts to 2 Touch Operating mode for
program “00” to ‘'09".
Press required memory program number then press
Start Pad.
Setting New Programs
Once Program Lock is released, you can again enter
new heating programs, change the Beep Tone and
Preheat Temperature.
How to read the Program List
It is possible to check the programs that have been entered into the oven’s 100 memory programs. With the
door open, press Start Pad and Number Pad “1" simultaneously (the oven will make an acknowledging beep).
After 2 seconds the display window will show each individual stage of each memory program in the order 00,
01, 02 etc. Finally it will display the Beep Tone setting ,the program lock symbol (P L) and programed hours for
Scheduled Cleaning Service (see page 22) before clearing to “0”.
* For example if you want to know what mode is programmed in 78,
1. After starting to show in the display from "00” press Stop/Reset Pad.
2. Press Number Pads “7” and “8”.
3. Press Start Pad. (The display will show from program 78 through the following Program number.)
-
17
-